The Eminence Basslite CA2010 10" Bass Speaker delivers the tone you want. Nice tight top end. Recommended for bass guitar. Excellent in either sealed or vented cabs.
Eminence recommends the Basslite CA2010 as a direct replacement speaker in the Gallian-Krueger Goldlite 410 GLX speaker cabinet.
Nice tight top end
Excellent in either sealed or vented speaker cabinets
Order 4 and make your 4x10 cab sound like new.
Basslite CA2010 10" 150W Bass Speaker
Nominal Basket Diameter: 10", 254mm
Nominal Impedance*: 8 ohms
Power Rating**: 150W
Usable Frequency Range: 48Hz-7kHz
Magnet Weight: 4 oz.
Gap Height: 0.28", 7.2mm
Voice Coil Diameter: 2", 50.8mm
Thiele & Small Parameters
Resonant Frequency (fs): 51Hz
DC Resistance (Re): 5.46
Coil Inductance (Le): 0.55mH
Mechanical Q (Qms): 17.5
Electromagnetic Q (Qes): 0.52
Total Q (Qts): 0.51
Compliance Equivalent Volume (Vas): 49 liters / 1.7 cu. ft.
Peak Diaphragm Displacement Volume (Vd): 126cc
Mechanical Compliance of Suspension (Cms): 0.27mm/N
BL Product (BL): 11.2 T-M
Diaphragm Mass inc. Airload (Mms): 37 grams
Efficiency Bandwidth Product (EBP): 98
Maximum Linear Excursion (Xmax): 3.5mm
Surface Area of Cone (Sd): 360.7 cm2
Maximum Mechanical Limit (Xlim): 7.0mm
Recommended Enclosure Volume
Vented: 17-51 liters/ 0.6-1.8 cu.ft.
Overall Diameter: 10.25", 260.4mm
Baffle Hole Diameter: 9.13", 231.9mm
Front Sealing Gasket: fitted as standard
Rear Sealing Gasket: fitted as standard
Mounting Holes Diameter: 0.28", 7.0mm
Mounting Holes B.C.D.: 9.73", 247.1mm
Depth: 4.75", 121mm
Net Weight: 3.6 lbs., 1.6 kg
Shipping Weight: 4.7 lbs., 2.1 kg
Materials of Construction
Copper voice coil
Die-cast aluminum basket
Aluminum Alloy Cone
Cloth cone edge
Solid composition felt dust cap
*Please inquire about alternative impedances.
**Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.
***The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.
Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance " LMS using 0.25" supplied microphone (software
calibrated) mounted 1m from wall/baffle " 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction " Hafler P1500 Trans-Nova amplifier " 2700 cu.ft. chamber with
fiberglass on all six surfaces (three with custom-made wedges)