- H68493 000000000 H68493000000000
Shure PGXD14/BETA98H Digital Wireless System with Beta 98H/C Mic
- Write a Review
The PGXD14/Beta98H Digital Wireless System from Shure adds the clarity of 24-bit digital audio to the legacy of trusted Shure microphone options for ...Click To Read More About This Product
6-Month* financing available.
Mic-up horns and percussion instruments with this convenient, quality wireless mic system.
The PGXD14/Beta98H Digital Wireless System from Shure adds the clarity of 24-bit digital audio to the legacy of trusted Shure microphone options for wireless performance. This system includes the Beta 98H/C, a precision-engineered miniature cardioid condenser microphone with integrated clip and gooseneck for horn applications, as well as a PGXD1 bodypack transmitter, and a PGXD4 receiver.
The Beta 98H/C is a premium cardioid condenser instrument microphone that clamps onto the bell of wind instruments or onto the rim of percussion instruments. The integrated gooseneck and ratcheting swivel joint allows the mic to be easily positioned and secured, and an isolation shockmount reduces the transmission of instrument 'key noise' and other mechanical noise. A gooseneck angle brace is included to provide better retention of the microphone placement during more active performances.
The rugged PGXD1 bodypack transmitter easily clips onto a belt or guitar strap, and provides you with a 20Hz - 20kHz frequency range, up to 10 hours of continuous use on 2 standard AA batteries (not included), and 200' of wireless freedom.
The PGXD4 receiver offers 24-bit/48kHz accurate sound, offers technology for incredibly accurate sound, auto frequency selection, and greater reliability thanks to its true digital diversity.
Consumer Alert:Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCCs wireless microphone website at: www.fcc.gov/cgb/wirelessmicrophones.
PGXD1 Transmitter with WA302 Instrument Cable
Rugged, compact bodypack with belt clip and instrument cable
20Hz - 20kHz frequency range captures every nuance of your tone
Power, mute, and battery status LED
Up to 10 hours of continuous use from 2 AA batteries
200' (60m) operating range
26dB of continuously adjustable gain to match variable input levels
PGXD4 Wireless Receiver
24-bit / 48kHz digital technology for incredibly accurate sound
Automatic frequency selection locates a clear channel instantly
One-touch sync automatically syncs the transmitter and receiver
True digital diversity delivers rock-solid wireless signal reliability
Up to 5 systems can be used at once
1.4" and XLR audio outputs
Included padded carrying case for portability and protection
1.6m hard-wired cable
Tailored frequency response for open, natural sound reproduction
Compact, lightweight construction provides a low degree of visibility
Interchangeable microphone cartridges are available:
RPM108 - Cardioid cartridge
RPM110 - Supercardioid cartridge
Audio input level: +10 dBV maximum, at minimum gain setting -16 dBV maximum, at maximum gain
Gain adjustment range: 26dB
Input impedance: 1MÎ
RF Output Level: 10 mW maximum (dependent on applicable country regulations)
Dimensions (HxWxD): 108mm x 64mm x 19mm (4.25" x 2.50" x 0.75")
Weight: 128g (4.5oz.) without batteries
Housing: Molded polycarbonate case
Battery Life: Up to 10 hours
Dimensions (HxWxD): 40mm x 181mm x 104mm (1.6" x 7.125" x 4.1")
Weight: 289g (10.2oz.)
Audio Output Level (ref. ±38kHz deviation, 1kHz tone): XLR connector (into 3000Î load): -2.5dBV 1/4" connector (into 10000Î load): +10 dBV
Sensitivity: -102 dBm @ 10-5 BER
Image rejection: > 70dB, typical
Impedance balanced Pin 1: Ground (cable shield)
Pin 2: Audio
Pin 3: No Audio
Red: 2dB below clip
Amber: 12dB below clip
Green: 50dB below clip
Power Requirements: 12-18 Vdc at 150 mA, supplied by external power supply
Pin Assignments: XLR: 1 = ground, 2 = hot, 3 = cold 6.35mm (1/4") TRS: Tip = audio, Ring = no audio, Sleeve = ground
Type: Condenser (electret bias)
Frequency response: 20 to 20,000Hz
Polar pattern: Unidirectional (cardioid)
Output impedance: Rated at 150Î (actual)
Recommended minimum load impedance: 1 kÎ (May be used with loads as low as 150Î with reduced clipping level
Output Level (0 dB = 1 volt per Pascal):
Open Circuit Voltage: -56dB (1.6mV)
Output Clipping Level (at 1kHz, THD < 1%):
2.5kÎ load: 11dBV (3.5V)
1.0kÎ load: 3dBV (1.4 V)
1.0kÎ load: 155dB
Dynamic Range (maximum SPL to A-weighted noise level): 132dB (2.5kÎ load)
Signal-to-noise ratio: 63dB at 94dB SPL (IEC 651)
Positive pressure on microphone diaphragm produces positive voltage on pin 2 relative to pin 3 of preamplifier output connector
Recommended Operating Voltage: 11 to 52 Vdc Phantom
Environmental conditions: Operating temperatures: -7 C to 49 C (20 F to 120 F)
Storage temperatures: 29 C to +74 C (-20 F to 165 F)
Relative Humidity: 0 to 95%
Net Weight: Microphone w/cable and preamplifier: 156g (5.5oz.)
Musician's Friend Gold Coverage
Gold Coverage goes above and beyond the manufacturer's warranty to protect your gear from unexpected breakdowns, accidental damage from handling and failures. This plan covers your product for one, two, three or up to five years from your date of purchase, costs just pennies per day and gives you a complete "no-worry" solution for protecting your investment.
Gold Coverage Includes:
- Unexpected and unintentional spills, drops and cracks
- Normal wear and tear
- Power surges
- Dust, internal heat and humidity
Other plan features include:
- For products over $200, No Lemon Policy applies. If it fails for the same defect 3 times, it is replaced on the 4th breakdown. (Does not apply to failures due to drops, spills, and cracks)
- For products under $200 experiencing the above failures, a Musician's Friend gift card will be issued for the full price of the product + tax.
- Shipping fees covered if required for repair or replacement
- Plans are transferable in the event merchandise is sold
- Plans are renewable on new gear
*Limitations and exclusions apply. See terms and conditions for program details
Term for New Gear begins on date of purchase but does not replace the store return policy or manufacturer coverage.
Reviewed by 1 customer
Displaying review 1
Comments about Shure PGXD14/BETA98H Digital Wireless System with Beta 98H/C Mic:
I have had mine now for several months and have enjoyed it. This mic works well for my tenor sax. I wind the extra wire around the bell of the horn and attach the sending unit to my lower pad guard and it is completely wireless and out of the way. Works great.