PVXp 12 Active PA Loudspeaker

PVXp 12 Active PA Loudspeaker Specifications:

• Frequency Range, 1 meter on-axis, swept-sine in ½ Space environment:
• 51 Hz to 20 kHz
• Frequency Response, 1 meter on-axis, swept-sine in anechoic environment:
• 60 Hz to 20 kHz (±3 dB)
• Usable Low Frequency limit (-10 dB point anechoic): 55 Hz
• Internal power amplifiers (@120 VAC line):
• Total of 800 watts peak available power
• Woofer - 650 watts peak available power
• Continuous Power: 325 watts @ less than 1% distortion
• Tweeter - 150 watts peak available power
• Continuous Power: 75 watts @ less than 1% distortion.
• Nominal sensitivity (1W @1M, swept sine input in anechoic environment):
• 97 dB (average)
• Maximum Sound Pressure Level (1 meter):
• 127 dB SPL peak with music
• Radiation Angle measured at -6 dB point of polar response:
• Nominal: 100 degrees horizontal X 50 degrees vertical
• (Axis of the vertical main polar lobe is angled down 10 degrees, resulting in the angular pattern with respect to straight ahead being +15, -35 degrees)
• Transducer Complement:
• Heavy-duty 12" woofer with 2 3/8" voice coil & 50 oz. magnet
• RX14 1.4" titanium diaphragm dynamic compression driver
• Box Tuning Frequency:
• 62 Hz
• Electroacoustic crossover frequency: 2,800 Hz
• Crossover type:
• Internal Electronic two-way crossover with driver EQ, level matching, bass
• boost and subsonic filtering.
• Crossover Slopes:
• 12 dB/octave (2nd order) low pass, 24dB/octave (fourth order) high pass,
• both with staggered poles and driver EQ.
• Input Connections:
• One combo female XLR/ 1/4" phone jack providing balanced line-level operation, with switch-selectable mic- or line-level sensitivity.
• Output Connections:
• One male XLR and one 1 /.4" phone jack. The Thru jacks are intended for the use of linking multiple PVx12D˜s in a line or to provide a feed to a powered subwoofer, or other electronics that needs to receive a full range version of the input signal.
• Enclosure Materials & Finish:
• Black ABS plastic with textured surface, black powder-coated perforated grille.
• Also available in white.
• Mounting provisions:
• Unit has two sets of two M10 inserts, one pair on the top, and one pair on the bottom.
• Additional mounting points are a set of four M8 inserts on the top, and a set of four on the right side in the handle recess, and a set of four on the bottom, which use the Peavey VersaMount 70+ mounting bracket.
• Four rubber feet provide vibration free floor or stage use, and a molded-in stand mounting cup is on the bottom.
• Dimensions (H x W x D):
• Front:
• 24.50 in. x 16.10 in. x 15.00 in.
• Rear:
• 22.75 in. x 8.75 in. x 15.00 in.
• Net Weight:
• 43 Lbs. (19.5 kg)