The Eminence Basslite S2010 10" Bass Speaker delivers the tone you want. It's recommended for bass guitar and ideal for vented 1x10", 2x10", and 4x10" enclosures.
Neodymium magnet for lighter weight
Put this replacement speaker in the cart.
Basslite S2010 10" 150W Bass Speaker
Nominal Basket Diameter: 10", 254mm
Nominal Impedance*: 8 ohms
Power Rating**: 150W
Usable Frequency Range: 54Hz-4kHz
Magnet Weight: 4 oz.
Gap Height: 0.28", 7.2mm
Voice Coil Diameter: 2", 50.8mm
Resonant Frequency (fs): 46Hz
DC Resistance (Re): 5.02
Coil Inductance (Le): 0.47mH
Mechanical Q (Qms): 4.16
Electromagnetic Q (Qes): 0.34
Total Q (Qts): 0.31
Compliance Equivalent Volume (Vas): 63.4 liters / 2.2 cu. ft.
Peak Diaphragm Displacement Volume (Vd): 140cc
Mechanical Compliance of Suspension (Cms): 0.36mm/N
BL Product (BL): 11.9 T-M
Diaphragm Mass inc. Airload (Mms): 33 grams
Efficiency Bandwidth Product (EBP): 135
Maximum Linear Excursion (Xmax): 4.0mm
Surface Area of Cone (Sd): 350.1 cm2
Maximum Mechanical Limit (Xlim): 8.0mm
Recommended Enclosure Volume:
Vented: 20-51 liters/ 0.7-1.8 cu.ft.
Overall Diameter: 10.08", 256mm
Baffle Hole Diameter: 9.05", 229.9mm
Front Sealing Gasket: fitted as standard
Rear Sealing Gasket:
Mounting Holes Diameter: 0.25", 6.4mm
Mounting Holes B.C.D.: 9.66", 245.4mm
Depth: 4.25", 108mm
Net Weight: 3.5 lbs., 1.6 kg
Shipping Weight: 4.6 lbs., 2.1 kg
Materials of Construction
Copper voice coil
Pressed steel basket
Cloth cone edge
Solid composition felt dust cap
*Please inquire about alternative impedances.
**Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.
***The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.
Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25" supplied microphone (software
calibrated) mounted 1m from wall/baffle | 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Hafler P1500 Trans-Nova amplifier | 2700 cu.ft. chamber with
fiberglass on all six surfaces (three with custom-made wedges)