Brixton 12W Tube Guitar Amp Head

The Brixton is essentially a high gain design but the combination of gain and volume controls let you dial in semi clean sounds as well.

Gain and Volume Control
These controls dial in the amount of Gain and Volume.

Deep Switch
Engaging the Deep switch will change the sound from tight focused with quick attack to full with increased bass and slower attack.

Voice Switch
The middle position is the normal voicing of the Brixton. Toggle the switch to the right for a brighter open sound, note that the higher the gain is set the less effective this is. If you toggle the switch to the left it will cut the volume, the amount of gain will stay or increase depending on the gain control, the gain structure changes to a more compressed type. Use this mode for bedroom levels or extreme high gain sounds.

Standby, Hi - Low Power Switch
After you turned the amp on and let the tubes heat up a few minutes you have the choice to switch the amp off Standby into the Hi or Low position. Hi has the full 12 watts available while Lo has 6 watts. The difference in loudness is not equivalent to half the power, maybe a third less. The amp will feel looser in the Lo position; readjust controls to your taste.