Crown X4000 Stereo 2x1350W Power Amp
- Write a Review
- SKU
- #H88829000000000
-
- MSRP:
- $1,698.00
-
- Your Savings:
- - $848.01
-
Free Shipping on Orders over $25
-
- Your Price:
- $84999
- Free Shipping
- Top Rated
- Top Seller
- Flexible Financing
- Price Match
- Satisfaction Guarantee
-
res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
-
res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
-
res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
- res13052306561442556586788
Crown power that won't bankrupt the kingdom.
The X Series of power amplifiers from Crown represents a new era in affordable, quality power amplification. All four models in the series are powerful, rugged and reliable. They are suited for musicians, DJs, and entertainers as well as houses of worship, discos, and pubs. Features include RCA and XLR inputs, user selectable input sensitivity of 0.755V or 1.4V, Speakon and binding post outputs, stereo/parallel/bridge-mono mode, power/fault/signal presence/clip indicators, forced-air cooling; and protection against shorts, no-load, on/off thumps and radio-frequency interference. The Crown X4000 has an output of 1350W per side at 4 ohms.
With more than six decades of experience designing and building rock-solid products, Crown is the standard in amplifier technology. Check out the affordable Crown X Series.
Features
- Stereo/parallel/bridge-mono mode
- User selectable input sensitivity - 0.775V and 1.4V
- Electronically balanced RCA & XLR inputs; binding post and Speakon outputs
- Efficient forced-air cooling prevents excessive thermal buildup
- Electronically balanced RCA & XLR inputs; binding post and Speakon outputs
- Two level controls, power switch, power LED, and six LEDs which indicate signal presence, clip and fault for each channel
- Protection against shorts, no-load, on/off thumps and radio-frequency interference
With great power comes great responsibility, or not. Order today.
X4000 Stereo 2x1350W Power Amp Specifications:
- Guaranteed Minimum Power: 1350W (per channel) @ 4 ohms / 1000W (per channel) @ 8 ohms / 2700W bridge mono @ 8 ohms
- Frequency Response (at 1 Watt): 20Hz - 20kHz, +0/-1dB
- Total Harmonic Distortion (THD): < 0.5%, 20 Hz - 20 kHz
- Intermodulation Distortion (IMD) 60 Hz and 7 kHz at 4:1, from full rated output
- to –30 dB: 0.35%
- Slew Rate: >10V/us
- Voltage Gain: 29dB 31dB 33dB 36dB
- Damping Factor (8 ), 10 Hz - 400 Hz > 200
- Signal-to-Noise Ratio: (below rated power,
- 20 Hz to 20 kHz, A-weighted): > 100 dB
- Crosstalk (below rated power)
- At 1 kHz: –75 dB
- At 20 kHz: –59 dB
- Input Sensitivity for full rated power at 8 0.775V or 1.4V
- Input Impedance (nominal)
- Balanced: 20 k
- Unbalanced: 10 k
- Connectors, Controls and Indicators
- Input Connectors: One balanced XLR and one unbalanced RCA per channel
- Output Connectors: (Speaker Connectors) 4-POLE Speakon® and one pair Binding Post per channel
- Front Panel Controls: Power on/off switch, one gain control per channel
- Rear Panel Controls Output mode switch: stereo (dual), parallel or bridge
- Input sensitivity switch: 0.775V or 1.4V
- Power Indicator: One blue LED
- Signal Indicator: One green LED per channel
- Clip (peak) Indicator: One yellow LED per channel
- Fault Indicator: One red LED per channel
- Construction
- Protection: Protection against short circuits, no-load, on/off muting,
- RF interference. Stable into reactive or mismatched loads
- Ventilation: Flow-through ventilation from front to back
- Cooling: Internal heat sinks with forced air. Fan cooled,
- speed regulated, thermal protection
-
RMX 1450 Power Amp -
Crown Xti Series Power Amps at Winter NAMM 2007 -
Cerwin-Vega Power Amps at Winter NAMM 2007
Review Snapshot®
by PowerReviews(based on 1 review)
Ratings Distribution
Reviews
Reviewed by 1 customer
Displaying review 1
Pros
- Clear
- Easy To Use
- Excellent Sound
- Good Warmth
- Powerful
Cons
- Weight
Best Uses
- Pa Mids
- Pa Subs
- Performances
Comments about Crown X4000 Stereo 2x1350W Power Amp:
I ordered this amp impulsively through the 'Deal of the Day' which I keep my eye on regularly. I had heard whisper of the new Crown line but hadn't seen any reviews yet. I did my homework and after realizing its limitations and its abilities, I took a risk at such a great price and purchased it. I contacted Crown and spoke to a tech there about this range. He advised me it was 'old school' technology, a little heavy but solid in its abilities. Today, I set it up through my PA and did a direct comparison between the Crown X4000 and my Crown XTI4002. Firstly, I expected to hear a slight difference in sound quality. Not so, any difference was inaudible to me. Secondly, I figured that although the XTI is rated at 650w into 8 ohms and the X4000 is rated at 1000w, in terms of volume, this should not make that much difference ( double the volume requires 10 x power). Again I was shocked to find that the X4000 was noticeably louder at the same gain setting. Overall, this is a great sounding amp even though it is a little heavy especially compared to my XTI and XLS amps. Also note it has no DSP so if you use a DRPA or similar like me, you won't need it. I would like to have seen a limiter built into the amp but as I set my volumes carefully, I am always watching for clipping and I can set my limiters in my DRPA, it should be fine. Bridging is available but only at 8 ohms. Again, this suits me. Impulse buy worked out !!!
Displaying review 1
